Electronic Balance Program Setting

The internal procedure of calling the electronic balance should be completed in the following steps:

1. Turn off the balance switch.

2. Press the tare key and the power button of the electronic balance at the same time, and immediately release the power button of the electronic balance, and continue to press and hold the tare button of the electronic balance.

3. When "CH5" appears on the display of the electronic balance, release the tare button of the electronic balance.

4. At this time, on the display of the electronic balance, the page numbers of the built-in programs of the electronic balance, such as L1, L2 and L0, will start to cycle.

5. When a page number other than zero appears, press the tare button of the electronic balance as needed, and the two digits of the page number and line code appear on the display, such as L11, L12 to L10, and the line code starts to appear in cycles.

6. When a shape code other than zero appears on the display of the electronic balance, you can press the tare button as needed. Three digits appear on the display of the electronic balance, and the last digit is the word code, such as displaying L111, L112 to L110 Then it starts to display in a loop.

7. According to the above method, the program of the electronic balance can be selected arbitrarily (mainly for observation, if you need to change the locking device of the program switch of the electronic balance).

It should be noted that if "Lxxx" appears on the display, it means that this program can only be read and cannot be changed. The L symbol indicates that the electronic balance program is locked. If "Cxxx" appears, it means that the electronic balance program switch is turned on and the program can be modified.